Silicon Iron Anodes are generally used in fresh water, seawater, or underground applications, possessing exceptional resistance to corrosion within a wide variety of environments. They have been widely used within the Cathodic Protection Industry for over 30 years, giving them a fully proven performance record.
With Silicon Iron Anodes’ low specific resistance, suitability for fresh water, sea water and deep grounded installations, as well as their proven low consumption rate and dependability, their position as the number one choice for Cathodic Engineers is well deserved. We can also supply the following materials alongside any anodes order: Metallurgical Coke Backfill, Calcinated Petroleum Coke Backfill, Steel Canisters, Complete range of Anode Cables.
Critical to their dependability are the manufacturing methods and quality controls that are enforced by the Foundry responsible for their manufacture. Silicon Iron Anodes should adhere to a quality Level 1 or Level 2 so that premature or catastrophic failure of anode systems is prevented. With over 20 years’ experience in manufacturing Silicon Iron Anodes, at Jennings Anodes USA we are able to provide anodes to a quality level that is unsurpassed throughout the globe with a typical quality of between Level 1 and 2. The x-rays below show ASTM Standard E186 (Vol II) from Level 1 down to Level 5 and illustrate the impact of low quality anode production.
Stick anodes are available with or without a chrome additive. This chrome additive enhances the performance of the anode system and is usually accepted as standard.
Cables are connected to anodes in one of three ways. Either a standard taper-pin connector is used or a light bulb recess is incorporated into the head of the anode. Both connection processes have proved themselves equally reliable over many years.
A further connection process that is similar to the taper-pin connector replaces the taper-pin with a threaded nut and bolt arrangement. This has also proved itself as a most reliable connection process. We at Jennings Anodes USA will obviously respond to individual requests concerning the choice of connector.
3. Sizes Available
The following sizes are available as standard:-
* Parallel Anode with no expanded head specifically manufactured for Durichlor 51 Company U.S.A.
4. Consumption Rates
For design purposes, a current density of not more than 30 amperes per square metre of anode surface is advised, although consumption rates of the anode is very low.
Typical rates are:- Normal – 0.5 Kg/ampere year
Chrome – 0.2 Kg/ampere year